SecurityKeypads

Supported Security Keypads

Iris 3405-L (V2)

• Features:
  • One button Arm Away (On), driver option "Verify pin on arm away" requires valid pin to arm.
  • One button Arm Home (Partial), driver option "Verify pin on arm home" requires valid pin to arm.
  • Panic
  • Motion Sensor
• HE Driver:
  • Iris V2 Keypad
• Operation:
  • Arm Away, On, or pin code + On
  • Arm Home, Partial, or pin code + Partial
  • Disarm, pin code + Off

---

Iris iL02_1 (V3)

• Features:
  • One button Arm Away (On)
  • One button Arm Home (Partial)
  • Panic
  • Motion Sensor
• HE Driver:
  • Iris V3 Keypad
• Operation:
  • Arm Away, On
  • Arm Home, Partial
  • Disarm, pin code + Off

---

CentraLite 3400-G

• Features:
  • 3 arming modes (left to right), Arm Home, Arm Away and Arm Night
  • Motion Sensor
• HE Driver:
  • CentraLite Keypad
• Operation:
  • Arm Home, pin code + Arm Home
  • Arm Away, pin code + Arm Away
  • Arm Night, pin code + Arm Night
  • Disarm, pin code

---

CentraLite 3400

• Features:
  • 3 arming modes (left to right), Arm Home, Arm Away and Arm Night
• HE Driver:
  • CentraLite Keypad
• Operation:
  • Arm Home, pin code + Arm Home
  • Arm Away, pin code + Arm Away
  • Arm Night, pin code + Arm Night
  • Disarm, pin code

---

General Notes

• All pin codes are 4 numeric characters, no other lengths will be accepted by the driver.
• Pin codes can be entered via driver details or via LCM
  • To enter via driver details using the "Set Code" command:
    • Enter an unused code position
    • Enter an unused pin code
    • Enter a common name for this pin code
    • Click "Set Code", the resulting code if accepted will be visible in Current States, lockCodes
  • To edit an existing code via driver details using the "Set Code" command
    • Enter the code position you wish to edit
    • Enter the existing or new pin
    • Enter the existing, or new name
    • Click "Set Code", any changes will be applied
• If you have difficulty with discovering a keypad, perform a factory reset following the steps below
  • Remove all batteries
  • While holding the tamper switch down (tamper is under the wall bracket), insert one battery (Iris V2 and CentraLite), or four batteries (Iris V3), release tamper after two seconds.
  • Insert remaining batteries if any, then start discover devices.