SecurityKeypads

From Hubitat Documentation
Revision as of 08:37, 22 March 2021 by Doug (talk | contribs)
Jump to: navigation, search
Go to the top of the page

Supported Security Keypads

Iris 3405-L (V2)

20190312 081100.jpg
Features
  • One button Arm Away (On), driver option "Verify pin on arm away" requires valid pin to arm.
  • One button Arm Home (Partial), driver option "Verify pin on arm home" requires valid pin to arm.
  • Panic
  • Motion Sensor
HE Driver
  • Iris V2 Keypad
Operation
  • Arm Away, On, or pin code + On
  • Arm Home, Partial, or pin code + Partial
  • Disarm, pin code + Off

Iris iL02_1 (V3)

20190312 081133.jpg
Features
  • One button Arm Away (On)
  • One button Arm Home (Partial)
  • Panic
  • Motion Sensor
HE Driver
  • Iris V3 Keypad
Operation
  • Arm Away, On
  • Arm Home, Partial
  • Disarm, pin code + Off

CentraLite 3400-G

20190312 081016.jpg
Features
  • 3 arming modes (left to right), Arm Home, Arm Away and Arm Night
  • Motion Sensor
HE Driver
  • CentraLite Keypad
Operation
  • Arm Home, pin code + Arm Home
  • Arm Away, pin code + Arm Away
  • Arm Night, pin code + Arm Night
  • Disarm, pin code

CentraLite 3400

20190312 081046.jpg
Features
  • 3 arming modes (left to right), Arm Home, Arm Away and Arm Night
HE Driver
  • CentraLite Keypad
Operation
  • Arm Home, pin code + Arm Home
  • Arm Away, pin code + Arm Away
  • Arm Night, pin code + Arm Night
  • Disarm, pin code

General Notes

All pin codes are 4 numeric characters, no other lengths will be accepted by the driver.

Pin codes can be entered via driver details or via Hubitat Elevation® Lock Code Manager

  • To enter via driver details using the "Set Code" command
    • Enter an unused code position
    • Enter an unused pin code
    • Enter a common name for this pin code
    • Click "Set Code", the resulting code if accepted will be visible in Current States, lockCodes
  • To edit an existing code via driver details using the "Set Code" command
    • Enter the code position you wish to edit
    • Enter the existing or new pin
    • Enter the existing, or new name
    • Click "Set Code", any changes will be applied
  • If you have difficulty with discovering a keypad, perform a factory reset following the steps below
    • Remove all batteries
    • While holding the tamper switch down (tamper is under the wall bracket), insert one battery (Iris V2 and CentraLite), or four batteries (Iris V3), release tamper after two seconds.
    • Insert remaining batteries if any, then start discover devices.


Retrieved from "https://docs.hubitat.com/index.php?title=SecurityKeypads&oldid=4449"