How to Remove a Device

From Hubitat Documentation
Revision as of 19:58, 11 September 2018 by Hubipete (talk | contribs)
Jump to: navigation, search

Unlike other devices, removal of Z-wave devices require Hubitat Elevation to be placed in "exclusion" mode*. Excluding Z-wave devices you wish to remove is extremely important. Failure to exclude a Z-Wave device before removing it can slow your hub down as it is constantly searching for it. You will also not be able to add the device to another network until it is excluded here.

To Remove a Z-Wave Device

  1. Click on the Settings link in your Hubitat Elevation Web Interface
  2. Click on the Z-Wave Information button
  3. Click on the Z-Wave Exclude button
  4. The hub is now ready to exclude your device. Follow the procedure in your device user manual to put the device in exclusion mode.
  • Note: this process requires access to the physical device and the device must be within range of Hubitat Elevation hub.


Removal of other devices:

  1. Click on the Devices link in your Web Interface
  2. Click on the device you wish to remove
  3. Scroll down and click the Remove button
  4. Click Done to confirm that you wish to remove the device

Your device has now been banished to the land of wind and ghosts. You can add the device again later if you desire.