Z-Wave Poller

The Z-Wave poller app corrects a polling issue with certain Z-Wave devices that do not display their state properly, but the issue only affects certain non Z-Wave Plus devices. To determine if your Z-Wave device is a candidate for Z-Wave poller, active your device manually, and watch the logs to see if the device does NOT register a change of state in the logs. If it doesn't, then it is a candidate for Z-Wave Poller, but if does register a change in the logs, you should not use the Z-Wave Poller app with it.

Installing the Z-Wave Poller app

1. From the Hubitat Web Interface select Apps
   
2. Choose Z-Wave Poller from the list of Hubitat Elevation™ Built-In Apps
   

Choose non Z-Wave Plus devices that require polling

1. Use the Select Dimmers to Poll dropdown menu to choose the Z-Wave dimmers you would like to poll, then choose Update.
2. Use the Select Switches to Poll dropdown menu to choose the Z-Wave switches you would like to poll, then choose Update.
3. When your devices are selected, select Start polling for selected devices.
   
4. You can pause Z-Wave polling at any time by opening the app and choosing either Stop polling for selected devices or Stop All Poling.
   
5. To assist with troubleshooting, you can also turn on Enable Logging
6. When you are finished, select Done.