Join and Reset Instructions v1
Before you can join your devices to your Hubitat Elevation™ hub, you must first remove them from the previous hub or bridge. While Zigbee devices can simply be removed and put into Paring Mode using the manufacturer's instructions, Z-Wave devices must be Excluded from their previous network before joining a new one. Exclusion will happen automatically when the device is removed from Hubitat Elevation™, however it is recommend that Z-Wave devices always be factory reset as well. If a device cannot be factory reset, or is in an unknown state, then it is recommended to do a General Exclusion in your Hubitat Elevation™ hub to be sure it isn't joined to the former Z-Wave mesh. Typically the same button on the device for inclusion is also used for exclusion. If Hubitat doesn't show Unknown Device Excluded in the log, then the General Exclusion has failed and the device probably won't be able to be joined. See How to Build a Solid Z-Wave Mesh for further detail on methods of Exclusion.
BOSCH
| BOSCH | PIR Motion Detector | ISW-ZPR1-WP13 | Zigbee |
Factory Reset
- Remove the cover by rotating it counterclockwise
- Press and hold the Connect button for 5 seconds
- After the button is released, the LED will blink quickly for a few seconds, go dark for a few seconds, then blink slowly to indicate it is in pairing mode.
- Battery powered Zigbee devices often pair easier when their batteries are removed for 10 seconds following a factory reset.
Join the Zigbee Network
- Remove the cover by rotating it counterclockwise
- From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Pairing on the Device Discovery page.
- See Discovering your devices for detail instructions.
- Press and hold the Connect button for 5 seconds
- After the button is released, the LED will blink quickly for a few seconds, go dark for a few seconds, then blink slowly to indicate it is in pairing mode
Leaving the Zigbee Network
- From the device's details page, select Remove Device, then Remove.
