Join and Reset Instructions v1

Before you can join your devices to your Hubitat Elevation™ hub, you must first remove them from the previous hub or bridge. While Zigbee devices can simply be removed and put into Paring Mode using the manufacturer's instructions, Z-Wave devices must be Excluded from their previous network before joining a new one. Exclusion will happen automatically when the device is removed from Hubitat Elevation™, however it is recommend that Z-Wave devices always be factory reset as well. If a device cannot be factory reset, or is in an unknown state, then it is recommended to do a General Exclusion in your Hubitat Elevation™ hub to be sure it isn't joined to the former Z-Wave mesh. Typically the same button on the device for inclusion is also used for exclusion. If Hubitat doesn't show Unknown Device Excluded in the log, then the General Exclusion has failed and the device probably won't be able to be joined. See How to Build a Solid Z-Wave Mesh for further detail on methods of Exclusion.

BOSCH

Brand	Device	Product Number	Device Type	Protocol
BOSCH	PIR Motion Detector	ISW-ZPR1-WP13	Motion Detector	Zigbee

Factory Reset

1. Unlock the battery cover and slide it upwards to remove.
2. Press upward on the tamper switch located in-between the batteries and keep it engaged while you remove both batteries.
3. Wait at least 4 seconds, but do not release the tamper switch.
4. Keep the tamper switch engaged while you reinsert both batteries.

Join the Zigbee Network

1. Unlock the battery cover and slide it upwards to remove.
2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Pairing on the Device Discovery page.
   • See Discovering your devices for detail instructions.
3. Remove both batteries for at least 10 seconds.
4. Reinsert both batteries. The LED on the front of the sensor will be solid for 2 seconds
5. The LED will begin to blink On > Off > On > Off > On > Off (5 for seconds) and will continue to blink in this cycle for up to 3 minutes
6. If the motion sensor does not pair with the hub in less than 3 minutes, perform another factory reset and repeat the above steps to join the Zigbee network.

Leaving the Zigbee Network

1. From the device's details page, select Remove Device, then Remove.

   ---

Leviton

Brand	Device	Product Number	Device Type	Protocol
Leviton	4-Scene Controller	VRCS4	Button Controller	Z-Wave

Factory Reset

1. On the 4-Scene controller, press and hold buttons 1 and 3.
2. Wait approximately 5 seconds until the LED turns amber and then solid red.
3. Release the buttons and the 4-Scene controller will be reset. NOTE: Factory reset does not exclude the device from any previous networks it has joined. The exclusion process must still be performed separately.

Join the Z-Wave Network

Leaving the Z-Wave Network