|
|
| (5 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| − | The Z-Wave poller app corrects a polling issue with certain Z-Wave devices that do not display their state properly, but the issue only affects certain non Z-Wave Plus devices. Older GE dimmers and switches are well known to have this problem when activated manually. If your GE devices pairs as "Generic Z-Wave Dimmer" or "Generic Z-Wave Switch" it is a candidate for needing Z-Wave Poller. Z-Wave Poller only works with devices that pair with these two drivers. To verify that your Z-Wave device is a candidate for Z-Wave poller, active your device manually, and watch the logs to see if the device '''does NOT''' register a change of state in the logs. If it doesn't, then it is a candidate for Z-Wave Poller, but if does register a change in the logs, you should not use the Z-Wave Poller app with it.
| + | <big>'''We're moving!''' Please visit http://docs2.hubitat.com for the latest documentation.</big> |
| | | | |
| − |
| + | <big> |
| − | | + | This document is available at: http://docs2.hubitat.com/en/apps/zwave-poller |
| − | === Installing the Z-Wave Poller app ===
| + | </big> |
| − | | |
| − | # From the Hubitat Web Interface select '''Apps'''[[File:Install Built-In App 2.0.png|none|thumb|600x600px]]
| |
| − | # Choose Z-Wave Poller from the list of Hubitat Elevation™ Built-In Apps[[File:Install Z-Wave Poller.png|none|thumb|600x600px]]
| |
| − | | |
| − | === Choose non Z-Wave Plus devices that require polling ===
| |
| − | | |
| − | #Use the ''Select Dimmers to Poll'' dropdown menu to choose the Z-Wave dimmers you would like to poll, then choose '''Update'''.
| |
| − | #Use the ''Select Switches to Poll'' dropdown menu to choose the Z-Wave switches you would like to poll, then choose '''Update'''.
| |
| − | #When your devices are selected, select '''Start polling for selected devices'''.[[File:Z-Wave Poller setup.png|none|thumb|600x600px]]
| |
| − | #You can pause Z-Wave polling at any time by opening the app and choosing either '''Stop polling for selected devices''' or '''Stop All Poling'''.[[File:Stop Z-Wave Poller.png|none|thumb|595x595px]]
| |
| − | #To assist with troubleshooting, you can also turn on '''Enable Logging'''
| |
| − | #When you are finished, select '''Done'''.
| |
Latest revision as of 20:29, 25 September 2022
